There are 3 positions on the timer switch:

1. I – turns lights on.
2. O – turns lights off.
3. 🕑 – lights cycle 6 hours on and then 18 hours off.

When you turn the switch to the 🕑 timer mode, the lights will turn on for 6 hours and then automatically turn off for 18 hours.  The lights will automatically turn back on at the same time the next day.   Note: Cycle start time may vary depending on changes in temperature and battery voltage.

Battery Installation and Operation:

1. Make sure the switch on the battery holder is in the off- O position.
2. Lift the three tabs on the battery box compartment and open cover. 
3. Insert 3 new D batteries (included) matching the polarity shown inside the battery compartment.
4. Close the cover and push tabs down to secure the battery box compartment.
5. Turn on LEDs by turning the switch to the On- I or 🕑 timer position.

1.    lf the product does not light:

1. Ensure the switch on the battery holder is in the I or 🕑 positions.
2. Ensure all batteries are new.

2.    lf the lights do not operate correctly on the timer mode:

1. Ensure switch is in the 🕑 timer position (the I position will keep lights on until turned off).
2. If the switch is in the  🕑 timer position, you may need to reset the function. Turn off unit and restart the function to restart at the desired time.
3. lt is normal for the automatic on and off times in 🕑 timer mode to vary slightly depending on changes in temperature and battery voltage.

3.    lf lights are dim or not all of the lights turn on:

1. Replace batteries with 3 new D batteries.
2. lf water collects in the battery compartment:

• Allow interior to completely dry and clean contacts.
• Re-seal and ensure that all the screws are installed and tight.